DutyCycles does not works collect on AnalogSequencer

Question

Firstly, I checked the DutyCycles in AnalogSequencer works correct on KymaX.

There are no clicks on steps at all.

Then on Kyma7, I hear the clicks on every steps.

Please let me know how to cancel the clicks.

testingSequencerOnX.kym

Comments

I have played something around with your sound and it works just fine. if you are using two audio interfaces maybe it is something wrong with your audio rate sync source or the sample rates are not the same?

---

Do you test the sound on KymaX?

The audio sample result is different between Kyma7 and KymaX.

On Kyma7, the retriggered clicks appears between the steps in legato mode.

http://www.mbiraski.com/audio/testSeqOnKyma7.aif

http://www.mbiraski.com/audio/testSeqOnKymaX.aif

And there is no trouble on my audio interface.

---

yes, i can hear it. unfortunately I run out of kyma x, so I can not test it.
But here are dutycycle amounts of zero in your sequence. that means the note will be off at this time. If you select only a 1 for dutycycles there are no clicks anymore, isn't it?

---

Yasuski, are you referring to the "chirp" of the filter?  I was able to more closely match the sound of your second recording by setting Resonance to 0.9.

---

One recent change in the StepSequencer is the addition of the KeyDowns parameter field.  What you have as KeyVelocities should probably be moved into the KeyDowns field.
Another change is that the StepSequencer no longer voice-steals on each step (allowing for an event to "ring" or decay over the several steps if there is no new KeyDown on that step).  One way to emulate the old behavior in the new version would be to set the Polyphony of the StepSequencer to 1 (rather than 2), setting the KeyDowns field to 1, and using the old method of using the KeyVelocities for switching stages on or off.  That would be closer to the old behavior.

---

Thank you for your support.

Unfortunately, I feel both of the method you advised me lost the tastes of the old style analog sequencer.

Well, I tried to get the old feeling from your advise.

Firstly, putting the "!KeyVelocity * (1 - !KeyDown) asLogicValue" in the gate field on AR,  and the values in DutyCycles field as "1" then set the array in the KeyDown field on the AnalogSequencer.  

I have uploaded the recorded audio files at:

http://www.mbiraski.com/audio/simulateTheOldStyleAnalogSeq.aif
http://www.mbiraski.com/audio/analogSequencer.mov

---

Great video, btw!!