Timeline WaitUntil

Question

I have made a new Timeline where I use WaitUntil and would like to send a message to move on. I have much older Timeline where I used WaitUntil successfully and I can't find what I am NOT doing on the new one for it to receive the MIDI message to move on. I have attached both. 

I am sending MIDI from Max and the working Timeline WORKS!

http://kyma.symbolicsound.com/qa/?qa=blob&qa_blobid=7275173620460204763

http://kyma.symbolicsound.com/qa/?qa=blob&qa_blobid=15371739633085585357

Comments

Hi Anne,

I've tested both and both work for me

---

Hi Anne,

We cannot open your files right now, but could you please check to see if the non-working timeline has the WaitUntil's track MIDI channel set to a different value than the working timeline?

---

This is a lesson for all!
I was using KymaControl for the WaitUntil with my iPad while I was building the Timeline and then I wanted to switch to using a pedal that would, through Max, send a !KeyDown. I had taken that out of the WaitUntil which meant that the WaitUntil was not receiving the appropriate message. A liability when switching control sources.

---

Sean, I solved the issue. See above.

Answer 1

This is a lesson for all!
I was using KymaControl for the WaitUntil with my iPad while I was building the Timeline and then I wanted to switch to using a pedal that would, through Max, send a !KeyDown. I had replaced the !KeyDown with a !Next button in the WaitUntil which meant that the WaitUntil was not receiving the appropriate message. A liability when switching control sources.